Dynasty L4-153 2.5L SOHC VIN K TBI (1992)
d. Apply a light coating of grease to the column lock flag and the park lock dowel pin.
3.
Place the ignition switch against the lock housing opening on the steering column. Ensure that ignition switch park lock dowel pin enters the slot in
the park lock slider linkage in the steering column.
4.
install ignition switch mounting screws. Tighten screws to 2 N-m (17 in lbs) torque.
5.
Install steering column covers. Tighten screws to 2 N-m (17 in lbs) torque.
6.
If the vehicle is equipped with a tilt steering column, install the tilt lever.
7.
To install the ignition key in the lock cylinder:
a. With the key cylinder and the ignition switch in the Lock position, insert the key cylinder into the ignition switch until it bottoms.
b. Insert ignition key into lock cylinder. While gently pushing the key cylinder in toward the ignition switch, rotate the ignition key until to the
end of travel.
c. Connect negative cable to battery.
8.
Check for proper operation of the halo light, shift lock (if applicable), and column lock. Also check for proper operation of the ignition switch
accessory, lock, off, run, and start positions.
