Dynasty L4-153 2.5L SOHC VIN K TBI (1992)
Tie Rod: Service and Repair
1. Loosen jam nut, then disconnect tie rod from steering knuckle.
2. Remove outer tie rod and jam nut, then the outer boot clamp.
3. Use pliers to expand boot snorkel clamp, then slide clamp onto breather tube.
4. Remove inner boot clamp, then mark breather tube location and remove boot.
5. Reverse procedure to install, noting the following:
a. Line up mark and breather tube location.
b. Install boot over housing lip with hole in boot aligned with breather tube.
c. Lubricate outer boot groove with silicone prior to installing outer boot clamp and ensure boot is not twisted.
d. Torque tie rod jam nut to specifications.
