Dynasty V6-181 3.0L SOHC (1991)
2.
To test proportioning valve when left rear wheel slides first, leave front brakes connected to valve, then proceed as follows:
a. Install gauge set No. C-4007A, as shown. A special adapter may be fabricated from a 7/16 X 24 tube nut, a short piece of brake tube and a 3/8
X 24 tube nut.
b. Bleed hose and gauge set.
c. While watching pressure gauges, have an assistant depress the brake pedal. Note gauge readings, then refer to
SPECIFICATIONS/MECHANICAL SPECIFICATIONS/HYDRAULIC BRAKE CONTROLS SPECIFICATIONS.
3.
If pressure readings are not as specified for left or right rear wheel, replace the combination valve noting the following:
a. After installing a new combination valve, bleed hydraulic brake system, refer to Brakes and Traction Control/Brakes/Service and Repair.
b. Upon completion of bleeding hydraulic brake system, reset brake warning switch by depressing brake pedal with moderate force. Brake
warning lamp will turn off when switch is reset.
