Dynasty V6-181 3.0L SOHC (1991)
* - NO CONTINUITY - *
B. Touch the test probe to the connector or wire to be measured.
C. Read the continuity on the DRBII display.
D. When continuity testing is done, press VOLT/OHM once to exit continuity meter mode.
How to Use the DRBII Menu
HOW TO USE THE DRBII MENU
The DRBII screen reads as follows:
DRBII
1) VEHICLES TESTED
2) HOW TO USE
3) CONFIGURE
4) SELECT SYSTEM
VEHICLES TESTED - The display will read:
VEHICLES SUPPORTED:
1991 CHRYSLER
PLYMOUTH/DODGE
JEEP & EAGLE
HOW TO USE - series of screens will be displayed about how to use the DRBII keys to move through the diagnostic program.
CONFIGURE - provides a menu of four DRBII functions, and enables you to view or change these functions. The functions are:
-
US/METRIC: enables you to have sensor, input, output, and other values displayed either In US standard units or in metric units.
-
KEY CLICK: enables you to choose to have either the green light illuminate or the beeper sound whenever a DRBII key is pressed.
-
KEY REPEAT: If key repeat is ON, the down arrow or up arrow key will scroll the display repeatedly; if key repeat is OFF, the down arrow or
up arrow key will scroll the display only one item at a time.
-
REMOTE DISPLAY: enables you to have what appears on the DRBII screen also displayed on another terminal screen.
When you select CONFIGURE, the display will read:
CONFIGURE
1) VIEW
2) CHANGE
VIEW: enables you to view the CONFIGURE menu. If selected, the display will read:
CONFIGURE
1) US/METRIC
2) KEY CLICK
Press the down arrow twice to view the rest of the menu. The display will change to read as follows:
CONFIGURE
2) KEY CLICK
3) KEY REPEAT
4) REMOTE DISPLAY
CHANGE: enables you to change the setting of any of the four DRBII functions under the CONFIGURE menu. If selected, the display will read:
CONFIGURE
1) US/METRIC
2) KEY CLICK
3) KEY REPEAT
Press the down arrow twice to view the rest of the menu. The display will change to read as follows:
CONFIGURE
2) KEY CLICK
3) KEY REPEAT
