Dynasty V6-181 3.0L SOHC (1991)
INSTALLATION
Conventional Regulator
Power Window Regulator Mounting
1.
Position the power window motor on the regulator with the pilot properly aligned in the pilot hole of the regulator plate.
2.
Check the window motor drive gear and sector gears for proper mesh.
3.
Secure the window motor to the regulator with three mounting screws.
4.
Secure the tie down bracket with one screw (if applicable).
5.
Remove the window block.
6.
Plug in the wiring harness to the window motor.
7.
Test the system for proper operation before reinstalling door trim panel(s).
Cable And Drum Regulator
Power Window Components
1.
Insert the window regulator assembly into the door.
2.
Anchor the regulator and motor with the original nuts and bolts. Install the cable retaining clips to the inner door panel.
3.
Connect the wiring harness to the power window motor.
4.
Connect the glass to the window lift plate.
5.
Test the system for proper operation before reinstalling door trim panel(s).
