dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Throttle Cable/Linkage|Service and Repair|Page 2308 > < Throttle Body Temperature Sensor|Specifications|Page 2304
Page 1
background image

Throttle Cable/Linkage: Service and Repair

Accelerator Pedal Assembly

REMOVAL

1.

Inside vehicle hold up the gas pedal and remove the throttle cable retainer and throttle cable from the upper end of the pedal shaft.  The throttle
lever must be rotated towards wide open throttle to allow enough cable slack to permit removal.

2.

From the engine compartment pull the throttle cable out through the dash, leaving the dash grommet in place.

Throttle Cable

3.

Remove the throttle cable from the throttle lever, then remove cable from throttle bracket.

 

INSTALLATION

Throttle Cable/Linkage|Service and Repair|Page 2308 > < Throttle Body Temperature Sensor|Specifications|Page 2304