Grand Caravan L4-153 2.5L SOHC VIN K TBI (1988)
brackets will be provided free of charge to involved dealers for use as required. Additional brackets, if needed, are available for ordering from
the parts depot.
Owner Notification and Service Scheduling
Owners will be notified of the service requirement aftershipment of the recall parts to involved dealers.
Service Procedure
^
The procedure for installing the bypass valve assembly on 1989 AS-Body models without trailer tow is the same as shown in the instructions
already provided in the dealer recall notification letter (# 281T) for trailer tow vehicles.
^
For 1989 AC-Body models, the procedure is the same as previously described for recall # 281T except there is no drilling required
(procedure step 3). A 1/4 inch hole already exists in the frame rail for the push-in tie strap to retain the valve assembly.
^
The procedure for 1990 AC and AY-Body models is also the same as previously described for recall # 281T except as follows:
FIGURE 11990 AC AND AY-BODY CARS
-
A plate is attached to the frame rail where the valve assembly is to be located. Therefore, a 1/4 inch hole must be drilled through the
plate (at the location shown in Figure 1 of this letter to accommodate the pushin tie strap.
