Grand Caravan L4-153 2.5L SOHC VIN K TBI (1988)
Input Shaft: Service and Repair
Fig. 16 Input shaft rear bearing cone installation
If transaxle case, input shaft seal retainer, bearing retainer plate, rear end cover, input shaft or input shaft bearings are being replaced, the
shim thickness must be determined. Refer to Transmission and Drivetrain/Manual Transmission/Transaxle/Input Shaft/Adjustments.
1.
Using puller C-293 and adapters C-293-45, remove input shaft rear bearing cone.
2.
Install input shaft rear bearing cone, using suitable press and tool L-4171.
3.
Using puller C-293 and adapter C-293-50, remove input shaft front bearing cone.
4.
Install input shaft front bearing cone, using suitable press and tool L-4462.
5.
Remove input shaft rear bearing cup, using suitable press, handle C-4171 and installer L-4520.
6.
Bolt on bearing support plate, then install input shaft rear bearing cup, using suitable press, handle C-4171 and installer L-4520. Press in bearing
cup until it bottoms.