dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Cowl Cover Ends - Unsnapped at Front Fenders|Page 9493 > < Cowl Grille/Outside Rear View Mirrors - Discolored
Page 1
background image

Cowl: All Technical Service Bulletins
Cowl Cover Ends - Unsnapped at Front Fenders

NO: 23-61-95

GROUP: Body

EFFECTIVE DATE: Oct. 27, 1995

SUBJECT:
Cowl Cover Fit

MODELS:

1996 (NS) Town & Country/Caravan/Voyager

SYMPTOM/CONDITION:

The cowl cover end(s) are unsnapped at the front fender(s).

DIAGNOSIS:

The retainer clip(s) on the fender(s) may be mis-located or a retaining tooth/teeth on the cowl cover may be broken, refer to Figure 1. If the retainer
clip(s) cannot be repositioned to provide proper retention or a retaining tooth is broken off of the cowl cover, perform the Repair Procedure.

PARTS REQUIRED:

1

4874300

Package, Cowl Cover Installation

1

4716284

Cover, Cowl

REPAIR PROCEDURE:

This bulletin involves installing a revised cowl cover.

1.

Raise the wiper arm pivot cover and remove the nut holding the wiper arm to the wiper pivot.

2.

Use a suitable two jaw puller to separate the wiper arm from the wiper pivot.

3.

Repeat steps 1 and 2 for the other wiper arm.

4.

Remove the 4 screws in the grille portion of the cowl cover attaching it to the wiper module.

5.

Disengage the 2 quarter turn fasteners located near the wiper pivots.

Cowl Cover Ends - Unsnapped at Front Fenders|Page 9493 > < Cowl Grille/Outside Rear View Mirrors - Discolored