dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

A-Pillar Trim|Page 9741 > < A-Pillar Trim|Page 9739
Page 5
background image

10. Remove screws holding quarter trim to quarter panel in B-pillar area.
11. Remove screws holding quarter trim to quarter panel from bolster area.
12. Remove screws holding rear edge of quarter trim to support bracket.
13. If equipped, disengage wire connector from accessory power outlet.
14. Separate quarter trim from quarter panel and pull front seat belt and turning loop through access hole in quarter trim.
15. Pull first rear seat belt through access hole in quarter trim.
16. If equipped, pull second rear seat belt through access hole in quarter trim.
17. Separate quarter trim panel from vehicle.

INSTALLATION

1. Place quarter trim panel in position on vehicle.
2. If equipped, insert and pull second rear seat belt through access hole in quarter trim.
3. Insert and pull rear seat belt and turning loop through access hole in quarter trim.
4. Insert and pull front seat belt and turning loop through access hole in quarter trim.
5. If equipped, engage wire connector into accessory power outlet.
6. Install screws to hold rear edge of quarter trim to support bracket.
7. Install screws to hold quarter trim to quarter panel in bolster area.
8. Install screws to hold quarter trim to quarter panel in B-pillar area.
9. Install screw to hold quarter trim to quarter panel above front seat belt retractor.

10. Install left front seat belt opening bezel into quarter trim.
11. Install second rear seat belts anchors.
12. Install first rear seat belt anchors.
13. Install left D-pillar trim panel.
14. Install upper left B-pillar trim.
15. Install left quarter trim bolster.
16. Install front door sill plate.
17. If equipped, install second rear seat.
18. Install first rear seat.
19. Connect the negative cable clamp to the battery post.

Liftgate CHMSL Access Panel

CHMSL Access Panel

REMOVAL

1. Using a trim stick (C-4755), Disengage clips holding CHMSL access panel to liftgate trim panel.
2. Separate access panel from vehicle.

INSTALLATION

1. Place access panel in position on vehicle.
2. Engage clips to hold CHMSL access panel to liftgate trim panel.

Liftgate Sill Plate

A-Pillar Trim|Page 9741 > < A-Pillar Trim|Page 9739