dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

A-Pillar Trim|Page 9746 > < A-Pillar Trim|Page 9744
Page 10
background image

Rear HEVAC Louver

REMOVAL

1. Using a trim stick (C-4755), pry lower edge of HEVAC louver away from headlining.
2. Separate louver from vehicle.

INSTALLATION

1. Place louver in position in HEVAC duct opening.
2. Push inward on louver until clips snap in place.

Right Quarter Trim Panel-Left on Four Door

Right Quarter Trim Panel - Left On 4 Door

REMOVAL

CAUTION:  Disconnect the negative cable clamp from battery post. Damage to accessory feed circuit can result.

1. Remove first rear seat.
2. If equipped, remove second rear seat.
3. Remove sliding door sill plate.
4. Remove quarter trim bolster.
5. Remove upper C-pillar trim.
6. Remove D-pillar trim panel.

A-Pillar Trim|Page 9746 > < A-Pillar Trim|Page 9744