Grand Caravan L4-2.4L DOHC (1996)
33.
Install the rear timing belt cover (Figure 12). Tighten the attaching bolts to 105 in-lbs (12 N.m).
34.
Install both camshaft sprockets. Tighten each attaching bolt to 75 ft-lbs (101 N.m) while holding the gear with special tool 6847 (Figure 11).
35.
Install the provided timing belt idler pulley. Tighten the mounting bolt to 45 ft-lbs (61 N.m).
36.
Set the crankshaft sprocket to TDC by aligning the sprocket with the arrow on the oil pump housing (Figure 14).
37.
Set the camshaft timing marks so that the exhaust camshaft sprocket is 1/2 notch below the intake sprocket (Figure 15).
NOTE:
Ensure that the arrows on both camshaft sprockets are pointing up.
38.
Install the provided timing belt. Start at the crankshaft, go around the water pump sprocket, the idler pulley, both camshaft sprockets and then
around the tensioner (Figure 14).
39.
Move the exhaust camshaft sprocket counter-clockwise to align the timing marks and take up the belt slack (Figure 14).
40.
Remove the pull pin from the new tensioner (Figure 14).
