Grand Caravan L4-2.4L DOHC (1996)
7.
Connect the electrical connector to the crankshaft position sensor.
8.
Install the air cleaner assembly and inlet air tube, then proceed to the reprogramming procedure.
Reprogramming the PCM:
1.
Connect the MDS (Mopar Diagnostic System) and DRB III (Scan Tool) to the vehicle and power them up.
2.
Use the arrow keys and select # 2 MDS DIAGNOSTICS on the DRB III MAIN MENU Screen.
3.
Use the arrow keys and select DIAGNOSTIC MENU on the MDS, then press NEXT MENU.
4.
Use the arrow keys and select CONTROLLER PROGRAMMING on the MDS, then press NEXT MENU.
5.
Use the arrow keys and select PROGRAM VEHICLE CONTROLLER on the MDS, then press NEXT MENU.
6.
Follow the steps presented on the MDS and DRB III which will allow the DRB III to obtain the current part number of the PCM.
7.
The MDS will display the part number of the PCM on the vehicle and the appropriate replacement part number, then press NEXT MENU to begin
programming.
If the PCM on the vehicle has already been updated or programmed, a NO UPDATES AVAILABLE message will be displayed. Check the part
number of the PCM on the vehicle and compare it to the part number displayed. If the PCM has already been updated, then another condition
exists that will require further diagnosis and repair.
8.
The MDS and DRB III will prompt for any operator action needed during the remainder of the programming process.
NOTE:
THE FOLLOWING STEPS ARE REQUIRED BY LAW.
9.
Type the necessary information on the "Authorized Software Update Label" and attach it to the PGM and cover the label with a clear plastic
sticker.
10.
Type the necessary information on the Authorized Modification Label and attach the label near the VECI Label.
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No:
08-19-43-94
0.5 Hrs.
FAILURE CODE:
FM - Flash Module
Labor Operation No:
08-15-80-93
0.2 Hrs.
Replace Crankshaft Position Sensor
