Grand Caravan L4-2.4L DOHC (1996)
17.
Remove the clockspring from the multi-function switch by depressing the two tabs on the clockspring (Figure 5). Discard the clockspring
assembly.
18.
Slide the new clockspring over the steering column shaft until the clockspring latches engage the multifunction switch housing (Figure 5).
19.
Connect the wire harness connectors to the clockspring assembly (Figure 4).
20.
Install the upper and lower shrouds onto the steering column (Figure 3). Tighten the screws securely.
21.
Install the steering wheel onto the steering column shaft.
22.
Install the steering wheel damper (if equipped).
23.
Install the steering wheel retaining nut. Tighten the nut to 45 ft-lbs (61 N.m).
24.
Connect the clockspring wire harness connectors to the speed control switches (if equipped) (Figure 2).
25.
Connect the clockspring airbag wire harness connector to the back of the airbag module (Figure 2).
26.
Connect the clockspring horn switch wire harness connector to the horn switch wire connector on the back of the airbag module (Figure 2).
27.
Install the airbag module onto the steering wheel. Make sure that the clockspring wire harnesses in the steering wheel hub area are not pinched
between the airbag module and the steering wheel.
28.
From the backside of the steering wheel, install the three (3) screws that secure the driver's airbag module to the steering wheel (Figure 1). Tighten
the screws to 100 in-lbs (11 N.m).
29.
With the ignition switch in the ON position, connect the negative battery cable.
30.
From outside the vehicle, turn the ignition switch to the OFF position for about 10 seconds and then turn it back to the ON position.
31.
Observe the airbag warning light in the instrument cluster. It should illuminate for 6-8 seconds and then go out.
NOTE:
If the airbag warning light fails to light or lights and stays on, there is a system malfunction. Refer to the proper Body Diagnostic Procedures
manual to diagnose and repair the problem.
