dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Check Engine Lamp Comes On and Fault Code 13|Page 2063 > < PCM - Cold Start Hesitation/Tip In Sag/DTC 13|Page 2058
Page 1
background image

Absolute Pressure Sensor: All Technical Service Bulletins
Check Engine Lamp Comes On and Fault Code 13

NO.: 18-09-91

GROUP:

DRIVEABILITY

DATE:

Sept. 23, 1991

SUBJECT:

Check Engine/Power Loss Lamp On - 3.0L Engine

MODELS:

1989

(AA)

SPIRIT/ACCLAIM

1988-89

(AC)

DYNASTY/NEW YORKER/LANDAU/SALON

1989

(AG)

DAYTONA

1989

(AJ)

LEBARON COUPE/LEBARON CONVERTIBLE

1987-89

(AS)

CARAVAN/GRAND CARAVAN/CARAVAN C/V
VOYAGER/GRAND VOYAGER

SYMPTOM/CONDITION:

The vehicle's "Check Engine/Power Loss" lamp comes on and Fault Code 13 "Map Pneumatic Change" is set into the diagnostic system.

DIAGNOSIS:

Using the DRB II tester and the appropriate diagnostic manual, verify that Fault Code 13 "MAP Pneumatic Change", and no other fault code, is present.
Visually inspect both the MAP sensor vacuum hose and wiring connector to insure proper installation. Perform the applicable tests in the diagnostic
manual to verify that the MAP sensor is operating properly.

PARTS REQUIRED:

1

MAP Sensor Relocation Package

4638458

Package Contents:
1

Cap Plug (1987-88 vehicles)

3580172

1

Cap Plug (1989 vehicles)

4241618

1

Purge Jumper Assembly

4669038

Consisting of:
1

In-Line Vacuum Connector

4201275

1

Vacuum Tee

33000227

1

11" Vacuum Hose

4104272

1

Bleed/Hose Assembly

4669042

Consisting of:

1

Vent

53007494

1

1" Vacuum Hose

4713956

1

Vacuum Tee

4669041

2

Vacuum Hose With 90 Degree Bend

4669044

1

Bracket

4686013

1

Wiring Harness

4687141

5

Tie Wraps

6015756

REPAIR PROCEDURE:

This repair involves relocation of the MAP sensor.

1.

Being sure that ignition key is in the OFF position, disconnect the negative battery cable.

2.

Disconnect wiring connector, vacuum hose and attaching bolts. Remove MAP sensor from its present location.

3.

Remove MAP sensor hose from vacuum tree on right side of intake manifold and install cap plug (3580172 for 1987 and 1988 vehicles or 4241618

Check Engine Lamp Comes On and Fault Code 13|Page 2063 > < PCM - Cold Start Hesitation/Tip In Sag/DTC 13|Page 2058