Grand Caravan V6-3.3L Flex Fuel (2008)
NOTE:
Remove the cap plug and nut at the rear of the front driver side sill plate, before attempting to remove the sill plate (Figure 13).
4. Carefully unsnap the lower "B" post trim panel (Figure 13).
5. Disconnect the power sliding door switch, located on the lower "B" post trim panel, from the body wiring harness connector (Figure 13).
6. Disconnect the affected chaffed wiring harness connector from the main wiring harness connector at the lower "B" post.
>
If the drive motor wiring harness requires repair, note the method used to tape the convolute and then remove the electrical tape from the
convolute. Slide the wires through the split in the convolute to expose the chaffed wires. Continue to Step 10 of this procedure.
>
If the power sliding door wiring harness requires repair, continue with Step 7 of this procedure.
