Grand Caravan V6-3.3L Flex Fuel (2008)
1. Screw the front tilt motor gearbox spindle (3) in or out as necessary until the motor retaining screws (4) and spindle screw (2) holes are aligned
and all fasteners can be installed.
2. Position the front tilt motor and gearbox assembly (1) onto the seat track.
3. Install the motor retaining screws (4). Tighten the screws to 12 Nm (106 in. lbs.).
4. Install the front tilt motor gearbox spindle (3) retaining screw (2). Tighten the screw to 17 Nm (150 in. lbs.).
5. Connect the motor electrical connector.
6. Install the power seat,See: Service and Repair/Removal and Replacement/Seat - Installation.
7. Verify proper power seat operation.
Removal
REMOVAL
NOTE: The procedure for replacing the seat leg latch release actuator and cable assembly is the same for both the 60 and 40 third row power
folding seats. The following steps should be performed only on the seat with the inoperative seat leg latch release actuator and cable assembly.
1. Remove the effected third row power folding seat,See: Service and Repair/Removal and Replacement/Seat - Removal.
2. Remove the seat cushion and cover assembly,See: Seat Cushion/Service and Repair/Seat Cushion / Cover - Removal.
3. Remove the cable assembly from the seat leg.
a. Remove the tie strap holding the switch wire harness and leg latch release cable to the seat leg assembly (3).
b. Push the cable connector (4) down to disengage it from the latch stud.
c. Remove the cable sleeve from the seat leg retaining bracket (5).
d. Pull the cable assembly up out of the seat leg.
e. Repeat this procedure for the other seat leg.
4. Remove the pushpin retainers (1) securing the seat leg latch release actuator and cable assembly (2) to the seat pan (6).
5. Disconnect the seat leg latch release actuator and cable assembly electrical connector (3).
