Grand Caravan V6-3.3L Flex Fuel (2008)
1. Position the seat riser (2) to the seat track and install the retaining two nuts (1) and bolts (3). Tighten the nuts and bolts to 48 Nm (35 ft. lbs.).
2. Install the wire harness retaining bracket (4) onto the seat riser.
NOTE: Heated seat shown. Non-heated seat similar.
3. If removed, install the seat track position sensor (8).
4. Position the seat track assembly (6) to the bottom of the seat cushion frame (5). Make sure the seat track is properly located and that the plastic
isolators are correctly installed.
5. Engage the four seat track mounting brackets (3) to the bottom of the seat cushion frame and install the retaining bolts (2). Tighten the bolts to 28
Nm (21 ft. lbs.).
6. Install the wire harness (7) to the bottom of the seat cushion frame and to the seat riser (9) and connect the wire harness connectors to the power
seat motors (1) and the seat track position sensor.
7. If equipped, install the heated seat module (4) onto the bottom of the seat cushion frame.
8. Position the seat bottom closeout (3) to the rear of the seat and install the push-pin retainers (1) that secure the two elastic straps (4) to the bottom
of the seat cushion frame (2).
9. Install the inboard seat cushion side shieldSee: Seat Cushion/Service and Repair/Seat Cushion Side Shields - Installation.
10. Install the seat into the vehicleSee: Service and Repair/Removal and Replacement/Seat - Installation.
2nd Row Swivel
INSTALLATION
NOTE: Right seat shown in illustrations. Left seat similar.
