Grand Caravan V6-3.3L Flex Fuel (2008)
1. Position the seat tracks to the bottom of the seat cushion frame (2) and install the six retaining bolts (3, 4 ,8 and 10). Tighten the bolts to 48 Nm
(35 ft. lbs.).
2. Install the seat cushion support (1) onto the seat cushion frame. Engage seat cushion support to the six retaining tabs (9) by using a small punch or
similar tool as a lever. Place the punch or tool through the six holes in the support and into the corresponding holes in the seat cushion frame, then
stretch the support over the retaining tabs.
3. If equipped with heated seats, connect the seat cushion wire harness connector to the heated seat wire harness.
4. Install the seat cushion and cover onto the seat cushion frame (7).
5. Engage the J-hook retainer (3) that secures the seat cushion cover to the front of the seat cushion frame.
6. Engage the four J-hook retainers (2 and 4) that secure the seat cushion cover to the sides of the seat cushion frame.
7. Engage the J-hook retainer (8) that secures the seat cushion cover to the rear of the seat cushion frame.
8. Install the eight spacers (6) onto the mounting studs of the seat tracks (1 and 5).
NOTE: Outboard side of seat shown. Inboard side similar. Illustration shown with seat back and hinges removed for clarity.
9. Position the seat tracks (2) and eight spacers (1) onto the pivot mechanism (3).
10. Install the four nuts (4) that secure each seat track to the pivot mechanism. Tighten the nuts to 48 Nm (35 ft. lbs.).
