Grand Caravan V6-3.3L Flex Fuel (2008)
2. Make sure abutment shims (4) are in place on both upper and lower slide abutments of caliper adapter (3).
NOTE: If the brake pads have a protective paper on the rear face of the brake pad plate, it must be removed before pad installation.
3. Place the brake pads (2, 5) in the abutment shims (3) clipped into the disc brake caliper adapter bracket (3) as shown.
CAUTION: Use care when installing the caliper (2) onto the adapter bracket to avoid damaging the guide pin boots.
4. Install the disc brake caliper (2) over the brake pads on the brake caliper adapter bracket.
CAUTION: When removing or installing a caliper guide pin bolt, it is necessary to hold the guide pin stationary while turning the bolt.
Hold the guide pin stationary using a wrench placed upon the pin's hex-shaped head.
5. Align the caliper guide pin bolt holes with the adapter bracket. Install the upper and lower caliper guide pin bolts (1). Tighten the guide pin bolts
to 35 Nm (26 ft. lbs.).
6. Install tire and wheel assembly (1)See: Maintenance/Wheels and Tires/Service and Repair/Removal and Replacement/Tires and Wheels -
Installation. Install and tighten wheel mounting nuts (3) to 135 Nm (100 ft. lbs.).
7. Lower vehicle.
8. Pump brake pedal several times to ensure vehicle has a firm brake pedal before moving vehicle.
9. Check and adjust brake fluid level as necessary.
10. Road test vehicle and make several stops to wear off any foreign material on brakes and to seat brake pads.
