Grand Caravan V6-3.3L Flex Fuel (2008)
4. Position master cylinder (1) on studs of power brake booster (2), aligning booster push rod with master cylinder piston.
5. Install two master cylinder mounting nuts (3). Tighten both mounting nuts to 25 Nm (19 ft. lbs.).
CAUTION: When tightening primary and secondary brake tube nuts at master cylinder, be sure brake tubes do not contact any other
components within vehicle and that there is slack in flexible sections of tubes. This is required due to movement between ABS ICU and
master cylinder while vehicle is in motion.
6. Thread primary (2) and secondary (3) brake tubes into master cylinder primary and secondary ports. Brake tubes must be held securely when
tightened to control orientation of flex section. Tighten tube nuts to 14 Nm (120 in. lbs.).
7. Connect wiring harness connector (2) to brake fluid level switch (1) mounted in brake fluid reservoir.
8. Connect negative battery cable to battery post.
9. Fill the master cylinder reservoir to the proper level.See: Brake Fluid/Service and Repair
