Grand Caravan V6-3.3L Flex Fuel (2008)
2. Using a new gasket, attach crossover pipe (1) to exhaust manifold and tighten bolts to 41 Nm (30 ft. lbs.).
NOTE: Inspect crossover pipe fasteners for damage from heat and corrosion. The cross-over bolts are made of a special stainless steel
alloy. If replacement is required, OEM bolts are highly recommended.
3. Install the remaining manifold attaching bolts. Tighten all bolts to 23 Nm (200 in. lbs.).
4. Install heat shield (2,4) and attaching screws.
5. Install and connect upstream oxygen sensor.
6. Raise the vehicle.
7. Attach catalytic converter pipe (4) to exhaust manifold using new gasket and tighten bolts to 37 Nm (27 ft. lbs.).
8. Connect downstream oxygen sensor connector.
9. Install the belt splash shield and lower the vehicle.
10. Install the wiper module.See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Wiper Module - Installation
11. Connect battery negative cable.
