Grand Caravan V6-3.3L Flex Fuel (2008)
1. Install the blend-air door (1) and the mode-air door (4) onto the pivots located in the inboard half of the rear heater-A/C housing (3).
2. Install the rear A/C evaporator (2) into the rear heater-A/C housing.
3. Align the pivot shafts of the blend-air door and the mode-air door to the pivot holes located in the outboard half of the rear heater-A/C housing and
install the two halves of the rear housing (3) together. Make sure the three plastic retaining tabs (1) are fully engaged.
4. Install the 15 screws (2) and three metal retaining clips (4) that secure the two halves of the rear heater-A/C housing together. Tighten the screws
to 2 Nm (17 in. lbs.).
5. Install the rear blend door actuator (4) and the rear mode door actuator (3) to the rear heater-A/C housingSee: Air Door/Air Door Actuator /
Motor/Service and Repair/Blend Door Actuator - Installation andSee: Air Door/Air Door Actuator / Motor/Service and Repair/Mode Door
Actuator - Installation.
6. Install the rear blower motor (2).
7. Install the rear blower motor resistor or power module (1) (depending on application) or.
8. Install the rear heater-A/C wire harness (5) onto the rear heater-A/C housing and connect it to the rear blower motor resistor or power module
