Grand Caravan V6-3.3L Flex Fuel (2008)
(depending on application), rear blower motor, rear blend door actuator and the rear mode door actuator. Make sure the harness connector is
properly secured to the side of the rear heater-A/C housing.
9. Install the rear heater core (3) into the end of the rear heater-A/C housing (1). Make sure that the foam seals are properly installed and that the two
retaining tabs (2) are fully engaged.
10. Install the screw (5) that secures the heater core tube bracket (4) to the rear heater-A/C housing. Tighten the screw to 2 Nm (17 in. lbs.).
11. Position the flange (5) onto the bottom of the rear heater-A/C housing (3). Make sure that the evaporator drain is clean and unrestricted.
12. Install the four screws (4) and four retaining clips (2) that secure the flange to the bottom of the rear heater-A/C housing. Tighten the screws to 2
Nm (17 in. lbs.).
13. If removed, install the rear A/C expansion valve (6) onto the rear A/C evaporatorSee: Expansion Valve/Service and Repair/Plumbing -
Rear/Installation.
14. Install the foam seal (1) onto the flange. If the seal is deformed or damaged, it must be replaced.
15. Install the rear heater-A/C housing.
