dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Procedures|Page 9053 > < Procedures|Page 9051
Page 5
background image

1. Fold the third row seat down to its storage position for easiest access to the seat belt lower anchor (4) on the quarter inner panel.
2. Remove the nut that secures the lower anchor to the stud on the quarter inner panel.
3. Remove the quarter trim bolster (2) from the quarter trim panel.See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and

Repair/Quarter Panel Trim/Quarter Trim Bolster/Removal.

4. Remove the quarter trim panel (5) from the quarter inner panel..

5. Pull the seat belt turning loop cover (2) down from the headliner far enough to access the screw securing the turning loop bracket.
6. Remove the screw that secures the turning loop bracket to the inner roof rail (1).
7. Disengage the tab on the turning loop bracket from the keyed slot in the inner roof rail.

8. Disengage the clips that secure the seat belt web guide (2) to the quarter inner panel (1).
9. Remove the screw (4) that secures the retractor (3) lower bracket to the quarter inner panel.

10. Lift the retractor upward far enough to disengage the retractor tab from the keyed slot in the quarter inner panel.
11. Remove the third row outboard seat belt and retractor from the vehicle as a unit.

Front

FRONT

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service.
Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing
further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental
airbag deployment.

WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,

Procedures|Page 9053 > < Procedures|Page 9051