Grand Caravan V6-3.3L Flex Fuel (2008)
Camshaft Position Sensor: Service and Repair
Camshaft Position Sensor - Removal
3.3/3.8L
1. Disconnect and isolate the negative battery cable at battery.
2. Remove the air box cover and inlet tube.
3. Disconnect camshaft position sensor electrical connector from the wiring harness connector.
4. Remove sensor bolt.
5. Rotate sensor away from block.
6. Pull sensor up out of the chain case cover. Do not pull on the sensor wiring. There is an O-ring on the body of the sensor. The O-ring may make
removal difficult. A light tap to top of sensor prior to removal may reduce force needed for removal.