Grand Caravan V6-3.3L Flex Fuel (2008)
Power Steering Line/Hose: Service and Repair
Power Steering Hoses - Installation
Pressure Hose
INSTALLATION
1. Place pressure hose into engine compartment using reverse order of removal. Push the pump end of hose up into engine compartment from
underneath, over rear of front suspension crossmember.
2. Raise and support vehicle.See: Wheels and Tires/Vehicle Lifting/Service and Repair
NOTE: Before installing power steering pressure hose on power steering gear, wipe clean connections with a lint-free cloth and replace
O-ring. Lubricate O-ring using clean power steering fluid.
3. Install pressure hose (4) into power steering gear (3) port. Thread pressure hose tube nut into gear, but do not tighten at this time.
4. Position pressure hose (1) routing clamps on rear of front suspension crossmember. Install and tighten screws (3) to 8 Nm (71 in. lbs.).
5. Position pressure hose (1) routing clamp at right side of front suspension crossmember. Install and tighten screw (2) to 8 Nm (71 in. lbs.).
6. Tighten pressure hose (4) tube nut at steering gear (3) to 31 Nm (23 ft. lbs.).
7. Lower vehicle.
