Grand Caravan V6-3.3L Flex Fuel (2008)
8. Due to track bar mounting, it will be easiest to locate right side pivot thru-bolt mounting hole first. Once located, insert a screwdriver or drift
punch through hole in right forward mounting bracket and bushing to temporarily hold it in place.
9. On left side of vehicle, Insert thru-bolt (3) through mounting bracket (4) and bushing. Install nut (1) on end of thru-bolt. Do not tighten at this time.
10. On right side of vehicle, remove previously installer screwdriver or drift punch and Insert thru-bolt (3) through mounting bracket (4) and bushing.
Install nut (1) on end of thru-bolt. Do not tighten at this time.
11. Remove jack stands from under rear axle.
12. On each side of vehicle, install tire and wheel assembly (1)See: Wheels and Tires/Service and Repair/Removal and Replacement/Tires and Wheels
- Installation. Install and tighten wheel mounting nuts (3) to 135 Nm (100 ft. lbs.).
13. Lower vehicle.
14. Position vehicle on alignment rack/drive-on lift. Raise lift as necessary to access the rear suspension while keeping vehicle at curb (riding) height.
