dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Front Door Exterior Handle - Installation|Page 10311 > < Front Door Exterior Handle - Installation|Page 10309
Page 1
background image

Front Door Exterior Handle: Service and Repair
Front Door Exterior Handle - Removal

REMOVAL

1.   Roll door glass up.

2.   Remove the watershield as necessary to gain access to the outside door handle. Refer to Front Door Panel. 

3.   Through access hole at rear of inner door panel, disconnect Vehicle Theft Security System (VTSS) switch connector from door harness, if

equipped.

4.   Disengage push in fasteners attaching VTSS switch harness to inner door reinforcement bar, if equipped.

5.   Disengage clip holding door latch linkage to door latch (Figure 1).

6.   Remove latch linkage from latch.

7.   Disengage clip holding door lock linkage to door latch.

8.   Remove lock linkage from latch.

9.   Remove nuts holding outside door handle to door outer panel.

10.  Remove outside door handle from vehicle.

Figure 1 OUTSIDE DOOR HANDLE

Front Door Exterior Handle - Installation|Page 10311 > < Front Door Exterior Handle - Installation|Page 10309