Grand Caravan V6-3.3L VIN E Flex Fuel (2007)
Trunk / Liftgate Position Sensor: Service and Repair
Installation
INSTALLATION
1. Perform a wiring repair on the full open switch wires following the approved procedure in the Wiring. Or install new terminals on the wire ends
and reinstall in the main liftgate motor electrical connector.
2. Position and install the full open switch retaining screw.
3. Install the power liftgate lift gear and link rod assembly.
4. Connect the battery negative cable.
5. Using an appropriate scan tool, check any erase any power liftgate control module diagnostic trouble codes.
6. Verify power liftgate system and full open switch operation. Cycle the power liftgate through one complete open and close cycle, this will allow
the power liftgate control module to relearn its cycle with the new components.
