Grand Caravan V6-3.3L VIN E Flex Fuel (2007)
proper precautions could result in accidental airbag deployment.
WARNING: To avoid personal injury or death on vehicles equipped with the occupant classification system (OCS), only the occupant
classification module (OCM) and the seat cushion trim may be serviced separately. All other components of the passenger side front seat
cushion assembly must be serviced only as a complete factory-calibrated, assembled and tamper-evident service replacement package. This
package includes the bladder, sensor, foam, wiring and a calibrated OCM. When installing this package always replace all of the existing
components with the new components as a unit. Do not attempt to separate or disconnect any of the new OCS components in the service
replacement package from each other, and do not attempt to reuse any of the replaced components in this or any other vehicle. Failure to take
the proper precautions could result in failure of the passenger airbag to deploy when required, or in passenger airbag deployment when not
required.
1. Place seat back into position.
2. Install both pivot bolts attaching seat back frame to seat track (Figure 1). Tighten bolts to 48 Nm (35 ft. lbs.) torque.
3. Install nuts attaching the recliner to the seat back frame. Tighten nuts to 12 Nm (105 in. lbs.) torque.
4. Install both seat cushion side covers.
5. Install the lumbar adjustment lever.
6. Install the seat back recliner lever.
7. Install the armrest.
8. Install headrest sleeves.
Figure 1 FRONT SEAT BACK
