Grand Caravan V6-3.3L VIN E Flex Fuel (2007)
9. Velcro old seat cushion cover onto new foam.
10. Engage J-strap retainers to hold seat cushion cover to cushion.
11. Install seat track rear cover (if equipped).
12. Install seat cushion outer side covers.
13. Do not reconnect the battery negative cable at this time. The supplemental restraint system verification test procedure should be performed
following service of any supplemental restraint system component.
14. Following successful completion of the supplemental restraint system verification test procedure, perform the Occupant Classification System
Verification Test using a diagnostic scan tool and the Occupant Classification Seat Weight special tool.
Removal
REMOVAL
1. Remove screws and plastic push pin attaching seat cushion side cover to bucket seat (Figure 1).
2. Disengage J-strap along rear of seat cushion to access screw.
3. Remove screw attaching rear of side cover to seat cushion frame.
4. Remove side cover from seat cushion.
5. If equipped, disconnect wire connector from power seat switch (Figure 2).
Figure 1 FRONT SEAT SIDE SHIELD
