Grand Caravan V6-3.3L VIN E Flex Fuel (2007)
1. Position the seat cushion cover/pad onto the cushion frame.
2. Engage the J-strap retainers.
3. Steam wrinkles from seat cushion, if necessary.
4. Install seat risers.
5. Install seat back.
6. Install seat into vehicle.
Removal
REMOVAL
1. Remove seat cushion cover.
2. Using a trim tool, unsnap the plastic clips and remove the cushion pan panel.
Installation
INSTALLATION
1. Place cushion pan panel onto the cushion frame routing the pull strap through the slot on the cushion trim..
2. Snap in the plastic clips on to the cushion pan..
3. Install seat cushion cover.
Removal
REMOVAL
NOTE: On leather trimmed seats, cushion cover can be removed from the cushion foam pad. On cloth trimmed seats, the cushion cover does
not separate from the foam pad.
1. Remove seat from vehicle.
2. Remove screws fastening rear grocery bag holders.
3. Remove inboard and outboard recliner covers.
4. Using a special tool C-4755, remove pull strap bezel.
5. Unzip both sides of the seat covers.
6. Disengage seat cushion cover J-straps from cushion pan panel.
7. Remove cover and foam from cushion pan panel.
Installation
INSTALLATION
NOTE: On leather trimmed seats, cushion cover can be removed from the cushion foam pad. On cloth trimmed seats, the cushion cover does
not separate from the foam pad.
1. Place the seat cushion cover and foam together.
2. Route pull strap through the slit on bottom of trim cover.
3. Pull trim cover around corners of frame and secure J-retainers.
4. Zip both sides of seat covers.
