Grand Caravan V6-3.3L VIN E Flex Fuel (2007)
6. Remove rear caliper from adapter using the following procedure. First rotate front of caliper up from the adapter. Then pull the rear of the caliper
and the outboard brake shoe anti-rattle clip out from under the rear abutment on the adapter (Figure 2).
Figure 2 Removing/Installing Caliper
7. If the brake rotor requires removal, it can now be removed by first removing the retainer clips from the wheel mounting studs, then pulling the
rotor straight off the studs.
Installation - Rear Disc Brake Caliper
INSTALLATION - REAR DISC BRAKE CALIPER
1. Completely retract caliper piston back into piston bore of the caliper.
2. If removed, install the brake rotor on the hub, making sure it is squarely seated on the face of the hub.
CAUTION: Use care when installing the caliper assembly onto the adapter, so the caliper guide pin bushings do not get damaged by the
mounting bosses.
3. Carefully lower caliper and brake shoes over rotor and onto the adapter using the reverse procedure for removal (Figure 1).
CAUTION: When installing guide pin bolts extreme caution should be taken not to cross-thread the caliper guide pin bolts.
