Grand Caravan V6-3.3L VIN E Flex Fuel (2007)
4. Remove bolt securing metal routing clip to rear of axle and remove sensor cable from metal clip (Figure 2).
5. Remove secondary (yellow) retaining clip at rear of wheel speed sensor head (Figure 3).
6. Push up on metal retaining clip (Figure 3) until it bottoms. This will release wheel speed sensor head from hub and bearing. While holding metal
clip up, pull back on wheel speed sensor head removing it from hub and bearing.
Figure 3 SENSOR CONNECTION AT HUB AND BEARING
7. Remove wheel speed sensor assembly from vehicle.
Installation
INSTALLATION
CAUTION: Proper installation of wheel speed sensor cable is critical to continued system operation. Be sure that cable is installed in routing
retainers/clips. Failure to install cable in retainers may result in contact with moving parts or over extension of cable, resulting in an open
circuit.
CAUTION: It is important that only Mopar(R)Wheel Bearing Grease be used for the following step application. Other lubricants may cause
sensor failure.
1. Lubricate the sensor O-ring with Mopar Wheel Bearing Grease before installation into the Hub And Bearing. If not lubricated, an improper seal
may result due to rolling of the O-ring.
2. If metal sensor retaining clip is not in the neutral installed position on hub and bearing cap, install from the bottom, if necessary, and push clip
upward until it snaps into position.
3. Install wheel speed sensor head into rear of hub and bearing aligning index tab with the notch in the top of the mounting hole. Push the sensor in
until it snaps into place on the metal retaining clip.
4. Install secondary (yellow) retaining clip over wheel speed sensor head and engage the tabs on each side.
5. Route sensor cable under leaf spring along rear of axle. Install speed sensor cable into routing clips on rear brake flex hose (Figure 2).
6. Install cable into metal routing clip and attach it to the rear axle with mounting bolt(Figure 2). Tighten mounting bolt to 16 Nm (140 in. lbs.).
7. Connect wheel speed sensor cable to vehicle wiring harness (Figure 1). Be sure speed sensor cable connector is fully seated and locked into
vehicle wiring harness connector.
8. Install speed sensor cable grommet into hole in floor pan making sure grommet is fully seated into hole.
9. Lower vehicle.
10. Road test vehicle to ensure proper operation of the base and ABS braking systems.
