Grand Caravan V6-3.3L VIN E Flex Fuel (2007)
Crankshaft - Installation
INSTALLATION
1. For main bearing identification, refer to (Figure 4). Lubricate with engine oil and install the crankshaft main bearing halves in the engine block.
2. Position the crankshaft in engine block (Figure 2) or (Figure 3).
3. Perform main bearing fitting procedure.
4. Inspect main cap bolts for stretching (Figure 1). Replace bolts that are stretched.
NOTE: The main cap bolts should be examined before reuse. Bolt stretch can be checked by holding a scale or straight edge against the
threads. If all the threads do not contact the scale the bolt must be replaced (Figure 1).
Figure 1 Check for Stretched (Necked) Bolts