Grand Caravan V6-3.3L VIN E Flex Fuel (2007)
1. Clean cylinder head and cover mating surfaces. Inspect cylinder head cover surface for flatness. Replace gasket as necessary.
2. Inspect the PCV valve hose for damage. Replace as necessary.
3. Inspect seal on the cover bolt for wear or damage (Figure 1). Replace bolt assembly as necessary.
NOTE: The cylinder head cover bolts contain a torque limiter sleeve and a seal (Figure 1). The seal and torque sleeve is replaced with the
bolt.
4. Assemble gasket to cylinder cover by inserting the bolt assemblies through each bolt hole on the cover and gasket (Figure 1).
Figure 2 PCV HOSE
5. Install cylinder head cover and bolts (Figure 2).
6. Tighten cylinder head cover bolts to 12 Nm (105 in. lbs.) (Figure 2).
NOTE: Be sure that the PVC valve is properly seated inside the cylinder head cover protrusion and the PCV valve hose completely
covers the protrusion of the PCV valve housing.
7. Connect PCV hose to cylinder head cover.
8. Connect spark plug wires to spark plugs.
9. Install wiper module.
10. Connect negative cable to battery.
