Grand Caravan V6-3.3L VIN E Flex Fuel (2007)
the housing.
5. Remove the center bezel outlets and housing from the center bezel as an assembly.
Figure 1 Center Air Outlets
Installation
CENTER BEZEL OUTLETS
1. Position the center bezel outlets and housing assembly onto the back of the instrument panel center bezel and engage the retaining tabs to the top
of the bezel.
2. Install the bottom of the outlet housing to the center bezel and install the three retaining screws. Tighten the screws to 2 Nm (17 in.lbs.).
3. If the vehicle is equipped with the ATC heating-A/C system, connect the infrared temperature sensor jumper harness to the infrared temperature
sensor located at the bottom of the center outlet.
4. Install the center bezel onto the instrument panel.
5. Reconnect the battery negative cable.
Removal
INSTRUMENT PANEL OUTLETS
1. Using a trim stick C-4755 or equivalent, disengage the retaining tabs that secure the outer perimeter of the instrument panel outlet to the
instrument panel top pad and remove the outlet (Figure 1).
