Grand Caravan V6-3.3L VIN E Flex Fuel (2007)
Brake Light Switch: Testing and Inspection
DIAGNOSIS AND TESTING - BRAKE LAMP SWITCH
NOTE: Before proceeding with this diagnostic test, verify the adjustment lever on the back of the switch is in the adjusted position. If the lever is in the
non-adjusted (diagonal) position it may have never been adjusted, Refer Brake Light Switch adjustments.
If the electrical circuit has been tested and the brake lamp switch is suspected of being faulty, it can be tested using the following method.
1. Remove the switch from the vehicle.
2. With the switch in the released position (plunger extended), use an ohmmeter to test each of the three internal switches as shown (Figure 1). You
should achieve the results as listed in the figure.
Figure 1 SWITCH TEST - RELEASED POSITION
3. Gently push the plunger on the brake lamp switch in until it stops.
4. With the switch in this depressed position (plunger pushed in), use an ohmmeter to test each of the three internal switches as shown (Figure 2).
You should achieve the results as listed in the figure.
Figure 2 SWITCH TEST - DEPRESSED POSITION
If you do not achieve the results as listed in both figures, the switch is faulty and must be replaced.
If the switch is found to be operating properly, it may be misadjusted. Do not reinstall the switch, replace it.
CAUTION: The switch can only be adjusted once. That is during initial installation of the switch. If the switch is not adjusted properly or has
been removed for any reason, a new switch must be installed and adjusted.
