Grand Caravan V6-3.3L VIN E Flex Fuel (2007)
5. Install Remover, Special Tool C-4150A, on the hub and bearing flange and wheel stud (Figure 6).
6. Tighten the Remover, pushing the wheel stud out the rear of the hub and bearing flange. When the shoulder of the wheel stud is past the flange,
remove the Remover.
7. Remove the wheel stud from the hub and bearing flange.
Installation
INSTALLATION
NOTE: Use one of the following procedures to install one of five studs on a hub and bearing flange.
DISC BRAKES
1. Rotate the hub and bearing flange around until the stud mounting hole lines up with the pocket in the brake adapter.
2. Insert the NEW wheel stud into the hub and bearing flange from the rear utilizing the pocket in the brake adapter (Figure 4).
3. Install several washers and a standard wheel mounting (lug) nut on the wheel stud (Figure 1). Install the nut so that the flat side of the nut is against
the washers to eliminate any binding.
Figure 1 Wheel Mounting Stud Installation
4. Tighten the wheel mounting nut (Figure 1) pulling the wheel stud into the hub flange. When the head of the stud is fully seated against the rear of
the hub flange, remove the nut and washers.
