Grand Caravan V6-3.3L VIN E Flex Fuel (2007)
8. Remove upper B-pillar trim cover (Figure 1).
NOTE: If equipped with the Occupant Classification System (OCS), there is a Belt Tension Sensor located on the lower seat belt anchor on the
passenger front seat belt.
9. Remove the lower seat belt anchor bolt (Figure 2).
Figure 2 BELT TENSION SENSOR/LOWER SEAT BELT ANCHOR
10. Disconnect the electrical connector if equipped with OCS (Figure 2).
11. Remove front door sill plate (Figure 1).
12. Remove sliding door sill plate (Figure 1).
13. Remove lower B-pillar trim cover (Figure 1).
14. Disconnect the seat belt retractor electrical connector (Figure 1).
15. Remove seat belt retractor attaching bolt (Figure 1).
16. Remove the seat belt and retractor from vehicle.
Installation
INSTALLATION
WARNING: Inspect the condition of the shoulder belt and lap belt. Replace any belt that is cut, frayed, torn, or damaged in any way. Also,
replace the shoulder belt if the retractor is either damaged or inoperative.
1. Place seat belt and retractor into position (Figure 2).
2. Install bolt attaching seat belt retractor to B-pillar (Figure 2). Torque bolt to 39 Nm (29 ft.lbs.).
3. Connect the seat belt retractor electrical connector (Figure 2).
4. Install the lower B-pillar trim cover (Figure 2).
5. Install the sliding door sill plate (Figure 2).
