Grand Caravan V6-3.3L VIN E Flex Fuel (2007)
Trunk / Liftgate Switch: Service and Repair
Installation
INSTALLATION
1. Install the handle switch in the light bar assembly (Figure 1).
Figure 1 REAR LIGHT BAR
2. Locate the two wires going to the exterior handle switch. Install the wires through the grommet and in the large connector. Secure with a tie strap.
NOTE: Be certain wires are reinstalled in the correct wire cavities. Failure to do so could result in damage to the handle switch. Refer to the
appropriate wiring information for complete circuit schematic or connector pin-out information.
3. Install the rear light bar.
4. Install the liftgate trim panel.
5. Connect the battery negative cable.
6. Using an appropriate scan tool, check any erase any power liftgate control module diagnostic trouble codes.
7. Verify power liftgate system and handle switch operation. Cycle the power liftgate through one complete open and close cycle, this will allow the
power liftgate control module to relearn its cycle with the new components.
