Grand Caravan V6-3.3L VIN E Flex Fuel (2007)
Installation
INSTALLATION
The power transfer unit half shaft inner seal is the smaller of the two seals located on the inside of the end cover.
1. Clean and inspect seal area.
2. Install seal with a 1 1/16 inch socket (Figure 1). The seal must be installed with the spring side of the seal facing end cover ball bearing. The seal
will bottom against a machined shoulder in the cover.
Figure 1 Seal Installation
3. Clean sealing surfaces of the end cover and P.T.U. case. Apply a bead of Mopar(R) Gasket Maker, Loctite Gasket Eliminator No. 518 or
equivalent.
4. Place end cover onto P.T.U. case and install bolts. Tighten bolts to 28 Nm (250 in. lbs.) in the sequence shown in (Figure 2). Retighten first bolt
after all other bolts are tight.
