Grand Caravan V6-3.3L VIN E Flex Fuel (2007)
Installation
INSTALLATION
The input shaft end seal is located on the end of the input shaft.
1. Clean and inspect seal area.
2. Remove input shaft from housing and stand on soft block of wood. Install input shaft end seal with seal installer 5065 and handle C-4171.
3. Lubricate seal lip after installing seal into input shaft.
4. Clean sealing surfaces of the end cover and P.T.U. case. Apply a bead of Mopar(R) Gasket Maker, Loctite Gasket Eliminator No. 518 or
equivalent.
5. Place end cover onto P.T.U. case and install bolts. Tighten bolts to 28 Nm (250 in. lbs.) in the sequence shown in (Figure 1). Retighten first bolt
after all others are tight.
CAUTION: When end cover is installed be careful not to damage the P.T.U. Input Shaft Cover Seal.
Figure 1 Bolt Tightening Sequence
6. Reinstall P.T.U. assembly.
7. Check and fill fluids as required.
Removal
REMOVAL
The Power Transfer Unit must be removed from the vehicle to service this seal. Refer to Power Transfer Unit Removal for procedures.
1. Remove P.T.U. end cover bolts (Figure 1).
