Grand Caravan V6-3.3L VIN R (2005)
Front Brake Rotor
INSTALLATION - FRONT BRAKE ROTOR
1. Install the brake rotor back on the hub and bearing (Figure 1).
2. Install brake caliper and adapter back over brake rotor aligning adapter with mounting holes on steering knuckle (Figure 1).
3. Install the two adapter mounting bolts securing the adapter to the steering knuckle. Tighten the mounting bolts to 169 Nm (125 ft. lbs.) torque.
4. Install wheel and tire assembly on vehicle. Tighten the wheel mounting lug nuts in proper sequence until all nuts are torqued to half specification,
then repeat the tightening sequence to the full specified torque of 135 Nm (100 ft. lbs.).
5. Lower vehicle to the ground.
Figure 1 Front Brake Mounting
Rear Brake Rotor
INSTALLATION
1. Completely retract caliper piston back into piston bore of the caliper.
2. Install the brake rotor on the hub, making sure it is squarely seated on the face of the hub.
CAUTION: Use care when installing the caliper assembly onto the adapter, so the caliper guide pin bushings do not get damaged by the mounting
bosses.
3. Carefully lower caliper and brake shoes over rotor and onto the adapter using the reverse procedure for removal.
CAUTION: When installing guide pin bolts extreme caution should be taken not to cross-thread the caliper guide pin bolts.
