Grand Caravan V6-3.3L VIN R (2005)
3. Install the rear hub and bearing (and connect wheel speed sensor where applicable) stopping short of installing the brake drum.
4. Install the rear park brake cable into its mounting hole in the rear brake support plate.
5. Install the park brake cable on the park brake actuation lever.
6. Apply sealant such as Mopar Gasket-In-A-Tube or equivalent around the wheel cylinder opening in the brake support plate.
7. Install wheel cylinder onto brake support. Install and tighten the wheel cylinder to brake support plate attaching bolts to 8 Nm (75 inch lbs.)
torque.
8. Install brake tube into wheel cylinder. Tighten tube nut to a torque of 17 Nm (145 inch lbs.) torque.
9. Install the rear brake shoes on the brake support plate.
10. Install brake drum.
11. Install the wheel and tire assembly. Tighten the wheel mounting nuts in proper sequence until all nuts are torqued to half specification, then repeat
the tightening sequence to the full specified torque of 135 Nm (100 ft. lbs.).
12. Adjust drum brake shoes.
13. Remove brake pedal depressor tool.
14. Bleed the brake system as necessary.
15. Lower the vehicle.
