Grand Caravan V6-3.3L VIN R (2005)
housing retainer fingers lock the housing and retainer firmly into place.
2. Attach the parking brake cable onto the park brake actuator lever.
3. Install the brake shoes on the rear brake support plate.
4. Insert cable housing retainer into body outrigger bracket making certain that cable housing retainer fingers lock the housing firmly into place.
5. Connect rear parking brake cable to the equalizer bracket (Fig. 115).
6. Install brake drum, and wheel and tire assembly.
7. Remove the locking pliers from the front park brake cable. This will automatically adjust the park brake cables.
8. Apply and release park brake pedal 1 time. This will seat the park brake cables.
INSTALLATION - FOLD-IN-FLOOR SEATING
1. Pass the leading end of the rear parking brake cable through the hole in the end of the intermediate bracket (Fig. 123). Press the cable housing
retainer through the hole until the fingers on the retainer lock it into place.
2. Route the cable back toward the brake assembly placing it in the routing clip fastened to the underbody of the vehicle (Fig. 119). Make sure to stay
to the inside of the left stabilizer bar link while routing either cable.
3. If the right rear cable is being serviced, install screws, attaching the cable routing clamps to the rear axle (Fig. 120).
4. Pass the cable through the hole in the brake adapter and hook the cable eyelet to the shoe lever (Fig. 121).
5. Install the screw fastening the cable to the rear brake adapter (Fig. 121).
6. Pull straight back on the front cable button (and pliers) and properly attach the equalizer to all three parking brake cables (Fig. 118).
7. Remove the locking pliers from the front parking brake cable and allow the automatic self-adjusting mechanism in the lever to take up any slack.
8. Lower the vehicle.
9. Apply and release park brake pedal 1 time. This will seat the parking brake cables.
