dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

System Description|Page 3533 > < System Description|Page 3531
Page 18
background image

-

checks A/C system performance based on evaporator temperature sensor input.

WARNING:  DO NOT OPERATE THE DCHA IN AN ENCLOSED AREA SUCH AS A GARAGE THAT DOES NOT HAVE EXHAUST
VENTILATION FACILITIES. ALWAYS VENT THE DCHA's EXHAUST WHEN OPERATING THE DCHA. REFER TO VENTING THE
DCHA's EXHAUST UNDER CABIN HEATER IN THE GENERAL INFORMATION PORTION OF THIS SECTION FOR PROPER
EXHAUST VENTING INSTRUCTIONS. FAILURE TO FOLLOW THESE INSTRUCTIONS CAN RESULT IN PERSONAL INJURY OR
DEATH.

CAUTION:  Do not activate the A/C Cooldown Test with the engine off. Failure to follow these instructions can result in internal damage to the DCHA
Heater Module.

-

The FCM monitors the PCI bus for the Cabin Heater Activation request. The request carries the status bit that the FCM requires to activate it's
Cabin Heater Assist Control output. This output is a low side driver (coming from FCM pin 15) which supplies a ground signal to the Cabin
Heater (pin 5). When the Cabin Heater receives this ground signal input, it interprets this as an activation signal.

-

The FCM low side driver is also capable of diagnostic sensing. The driver will sense an open circuit when the driver is off, and will sense a
short to voltage when the driver is on. The FCM will set DTC's for both of these types of faults. For additional information, refer to Cabin
Heater under General Information and Diagnostic Procedures.

-

will not run the air conditioning portion of this test if ambient temperature is below 12° C (53° F).
-

The forced Cabin Heater activation will occur even if the air conditioning portion of this test fails to initiate because AC Cooldown test criteria
was not met. When activated, the DCHA will operate for approximately seven minutesThree minutes to run and four minutes to purge.

-

will pass the air conditioning portion of this test if the evaporator temperature drops 6.7° C (20° F) within two minutes of starting this test.

-

messages (air conditioning related only) display on the DRBIII(R) after running this test.
-

These messages will clear after paging back out of this test. Therefore, it is important to note all of the AC Cooldown test messages before
doing so.

-

All Cabin Heater-related DTC's display under Cabin Heater, Read DTC's.

-

will cause the DELAY and Snowflake VF segments on the ATC to flash for 162 seconds (RG with DCHA only). If the air conditioning portion of
this test fails, the DELAY and Snowflake VF segments will continue to flash until the vehicle is driven more than three miles.

MANUAL TEMPERATURE CONTROL (MTC)

Vehicle Compatibility For MTC Modules

MODULE USAGE

SYSTEM AVAILABILITY

-

Three different types of systems are currently available for these vehicles.
-

Single-Zone Air Conditioning System

-

Dual-Zone Air Conditioning System

-

Three-Zone Air Conditioning System

System Description|Page 3533 > < System Description|Page 3531