Grand Caravan V6-3.3L VIN R (2005)
An audible chime or chimes will accompany any displayed warning messages. Chime requests with an OPEN message are dependent upon vehicle
speed.
The CT/CMTC/EVIC will not display information for any of the screens for which it did not receive the proper PCI bus data. Refer to the symptom list
in the Overhead Console section for problems related to the CT/CMTC/EVIC.
The CMTC/EVIC receives the following messages from the Body Control Module (BCM):
-
Verification of US/Metric status
-
VF display dimming brightness and exterior lamp status
-
Elapsed Ignition On Time data
-
Average Fuel Economy
-
Distance to Empty
-
Distance to service
-
Driver warning messages
The CT/CMTC/EVIC receives the following messages from the Front Control Module (FCM):
-
Outside Temperature
The CMTC/EVIC receives the following messages from the Powertrain Control Module (PCM):
-
Trip Odometer data
-
Vehicle Speed
The EVIC receives the following messages from the Adjustable Pedal System Module (APS):
-
APS status warnings
The CT/CMTC/EVIC receives the following messages from the Sentry Key Remote Electronic Entry Module (SKREEM):
-
Tire Pressure information
The CMTC/EVIC transmits the following messages to the BCM:
-
Status Request: Beep, Reset, US/M Toggle
-
Current Display
STEP BUTTON
The STEP Button can be used in one of the following three ways:
1. To sequentially select one of seven displays or blank display in the following order:
-
Average Fuel Economy
-
Distance to Empty
-
Trip Odometer
-
Time Elapsed
-
Distance to Service Message
-
Off (Blank)
2. To set the magnetic variance zone when VARIANCE = X (X = 1 - 15) is indicated in the VF Display.
3. To select the displayed programmable feature setting. (When equipped.) MENU BUTTON (EVIC only) For complete information of the
programmable features and memory messages. Use the MENU button to sequentially step the EVIC through the programmable features.
MENU BUTTON (EVIC only)
For complete information of the programmable features and memory messages.Use the MENU button to sequentially step the EVIC through the
programmable features.
RESET BUTTON
The RESET Button has two different functions:
1. To clear the trip functions that may be reset
2. To enter and exit the diagnostic mode
Pressing the RESET button once will clear the trip function that is currently being displayed (except Distance to Service) and the CMTC/EVIC will send
a PCI bus beep request to the BCM. If the RESET button is pressed again within 3 seconds, the CMTC/EVIC will reset ALL of the trip functions and an
additional beep request is sent to the BCM.
The trip functions that may be reset are:
-
Average Fuel Economy
-
Trip Odometer
-
Elapsed Time
