Grand Caravan V6-3.3L VIN R (2005)
RKE
remote keyless entry
RX
receive
SAB
seat airbag
SBS
seat belt switch
SBT
seat belt tensioner
SKREEM sentry key remote entry module
SQUIB
also called initiator (located inside airbag)
SRS
supplemental restraint system
TCM
transmission control module
TPMS
tire pressure monitor system
TX
transmit
VFD
vacuum fluorescent display
VTSS
vehicle theft security system
DRB III Error Messages and Blank Screen
DRBIII(R) ERROR MESSAGES
Under normal operation, the DRBIII(R) will display one of only two error messages: user-requested WARM Boot or User-Requested COLD Boot. If the
DRBIII(R) should display any other error message, record the entire display and call the STAR Center. This is a sample of such an error message
display:
ver:2.14
date: 26 Jul93
file: key_iff.cc
date: Jul26 1993
line: 548
err: 0xi User-Requested COLD Boot
Press MORE to switch between this display and the application screen.
Press F4 when done noting information.
DRBIII(R) DOES NOT POWER UP (BLANK SCREEN)
If the LED's do not light or no sound is emitted at start up, check for loose cable connections or a bad cable. Check the vehicle battery voltage (data link
connector cavity 16). A minimum of 11 volts is required to adequately power the DRBIII(R). Check for proper grounds at DLC cavities 4 and 5.
If all connections are proper between the DRBIII(R) and the vehicle or other devices, and the vehicle battery is fully charged, an inoperative DRBIII(R)
may be the result or a faulty cable or vehicle wiring.
DISPLAY IS NOT VISIBLE
Low temperatures will affect the visibility of the display. Adjust the contrast to compensate for this condition.
DRB III Safety Information
WARNING: EXCEEDING THE LIMITS OF THE DRBIII(R) MULTIMETER IS DANGEROUS. READ ALL DRBIII(R) INSTRUCTIONS
BEFORE USING THE MULTIMETER. FAILURE TO FOLLOW THESE INSTRUCTIONS CAN RESULT IN PERSONAL INJURY OR
DEATH.